A SERVICE OF

logo

Open as PDF
next previous
2-30
Installing the Series 8200zl Switch
Installation Procedures
Installing the Series 8200zl
Switch
Console Cable Pinouts
The console cable has an RJ-45 male connector on one end and a DB-9 female
connector on the other end. Table 2-16 describes the mapping of the RJ-45 to
DB-9 pins.
Figure 2-15. RJ-45 to DB-9 pinouts
Table 2-16. Mapping of RJ-45 to DB-9
Telnet Console Access
To access the switch through a telnet session, using an Ethernet port not the
Console port, follow these steps:
RJ-45 (Signal reference from
Chassis
DB-9 (Signal reference from PC)
RTS 1 8 CTS
TX_Debug 2 6 DSR
TXD 3 2 RXD
GND 4 5 GND
DCD 5 1 DCD
RXD 6 3 TXD
RX_Debug 7 4 DTR
CTS 8 7 RTS
9RI
5
4321
9
876
12345678
12345678