© Titan Tool Inc. All rights reserved. 33
3. Remove the plastic plug from the gun support bar. Slide
the extension bar through the clamp upright and the gun
support bar to the desired position. Tighten the clamp
knob to secure the clamp upright and the extension bar.
Main Bar
Clamp Upright
Extension
Bar
Clamp Knob
Remove plastic plug.
NOTE: The gun support bar has a clearance hole for
the clamp knob to go through and tighten on the
extension bar.
4. Mount the gun holders as shown in the Cart Assembly
exploded view drawing in this section.
5. Locate the second gun outlet on the pump lter. Remove
the plug and install the hex nipple and ball valve. Thread
the second gun hose onto the hex nipple.
NOTE: Once the second gun is in position, the trigger
cables can be installed on both guns. Make
sure the trigger cable from the second gun is
disconnected before performing the next step.
6. Insert the cable bushing into
the guide plate. The rst gun
cable and the second gun
cable should be parallel.
7. Insert the hooked end of the
cable into the lever plate.
Make sure it engages the
plate.
8. Reconnect the trigger cables
to the guns. Connect both
cables to the blocks.
Tension Adjustment
To increase tension, loosen the screw in the cable tension clamp
block on the gun arm. Slide the block forward to increase the
gap between the lever and the point where the trigger touches
the gun arm.
To decrease tension, slide the block backwards. Make sure
there is about 1/32” to 1/16” gap between the trigger lever and
where the trigger touches the bar.
Check gap here
Cable Tension
Clamp Block
IMPORTANT: Always turn the trigger lock on the spray gun
to the locked position before making any adjustments to
the gun. Also, release the trigger cable from its block by
lifting the cable up and out of the block. There will be a brief
triggering of the gun while releasing the trigger cable.
Electrical Schematic
Engine
Wire Assembly
779-147
Wire Assembly
779-149
Wire Assembly
779-148
YELLOW
YELLOW
PINK
Wire Assembly
779-242
12V Adapter
BLACK
GREEN
GREEN
Ground
Engine Stop
Switch
