Filter
Top Products
Chapter 3: Web Interface
b. Square – The camera will patrol along the user defined boundary in a clock
wise manner.
c. Pan only – The camera will perform Pan function only.
d. Tilt only – The camera will perform tilt function only.
e. In sequence (1-5) – The camera will jump to each Hotspot location in
sequence and wait for 10 seconds in each spot.
Pan speed / Tilt Speed
Use this to define the Pan and Tilt speed. By default this is set to 10, the
fastest setting. The administrator can further customize by choosing different
Pan / Tilt speed.
2.3.3 Network
This option determines WebCAM Network settings.
ii. IP Address
By default, the IP address acquisition is set to using DHCP.
Fig.16 WebCAM IP Address Settings
IP Address
This determines WebCAM LAN IP address.
Subnet Mask
Enter WebCAM Subnet Mask. The value is normally 255.255.255.0
Gateway
This item is to set WebCAM Gateway.
To learn more about the above, see Appendix C: IP address, Subnet and
Gateway
Obtain an IP address
This allows the user to choose either to set WebCAM LAN IP address; manually,
using DHCP (default) or using Bootp protocol.
Note:
Click Apply to confirm. WebCAM will reboot. You MUST manually enter the NEW
IP address in your Browser in order to open the Web Interface.
iii. DNS Server IP
WebCAM - user manual -18-