Filter
Top Products
Chapter 3: Web Interface
Fig.24 WebCAM Permit Hours Configuration
Click Configure to set the hours. The Administrator can set up to 4 different
Permit Hours (in 24hr format). Click Apply to save. Click Close to exit
without saving.
Note:
The Reset button only revert the fields to initial values prior to any changes being
made. If Apply has been clicked, it will not undo the changes.
ii. Block IP address
Fig.25 Blocking LAN IP address
Blocked IP List
This allows the Administrator to block specific LAN IP address from accessing
WebCAM. Enter the IP address in dotted decimal notation and click Add
Block IP. The blocked LAN IP address will be listed at the bottom.
Click Delete to remove it from the list.
WebCAM - user manual -25-