Filter
Top Products
- 57 -
Remote Controller
Network Camera provides a remote controller to command the camera’s pan/tilt and
other functions. The direction control part provides the function as on the main web
page.
The Pan/Patrol/Stop functions are also the same as on the main web page.
“Auto Patrol” This button commands the camera to patrol between the preset
positions on the patrol list that was set on the “Camera control page”. After each patrol
cycle, the camera stops at the original staring position. “Auto Pan” This button
commands the camera to pan from the current position to the left most or right most
and back. After panning both horizontal end positions, the camera would stop at the
original starting position.
“Center” This calibrates the camera’s position to aim at the center as the camera boots
up.
“Stop” This stops the auto movements (auto pan & auto patrol) of the camera.
Direction control
area
Auto movement
control area