Filter
Top Products
-
34
-
4.7 Motion Detect
*This function can only be configured in Windows Internet Explorer.
The Motion Detect menu contains the command and option that allow you to enable and set up the
motion detection feature of the camera. The camera provides two detecting areas.
To enable the detecting area, select Window 1 or 2 from the pull-down list, and then check Enable.
When the detecting area is enabled, you can use the mouse to move the detecting area and change the
area coverage.
- Name: Assign a name to the detecting area.
- Threshold: Move the slide bar to adjust the level for detecting motion. Make sure the threshold (the
horizontal line) is low (sensitive) enough to come across the waves (appear when motion detected),
so that the events (i.e, emailing snapshot, FTP uploading) you set up in Event Config will be
triggered.
NOTE Sliding the Threshold bar to the right will decrease the sensitivity of motion detection; sliding the
Threshold bar to the left will increase the sensitivity of motion detection.