Filter
Top Products
64
Click Browse… to select the location where the firmware file is stored.
4. Click submit.
5. The auto upgrade runs.
The Upgrade Status shows the progress of the upgrade.
When the firmware upgrade has been completed, the machine reboots automatically.
Reconnect to the server after 60 seconds.
Note: The new firmware is burned into the Flash ROM during the upgrade, so you
must take care during the process and make sure it is not interrupted during the
operation. The system may be damaged seriously and need to be returned to the
factory for repair if the power cable is removed or becomes loose during the upgrade.
Firmware upgrading in wireless network environment is not recommended because
unstable packet transmission may bring about loss of data.
When the firmware upgrade has been completed, you don't need to restart the camera
manually. The camera will reboot automatically after 60 seconds (Reboot OK). Then
open the IE browser and key in the IP address (The original IP address remains
undeleted).