Filter
Top Products
7
INSTALLATION
Refrigerator Surface Installation
1. Remove the protective backing from one side only of the two adhesive foam pads; position them on the back of the
wall mount bracket as shown.
2. Clean the intended mounting area on the refrigerator with isopropyl alcohol.
NOTE: Do not use a glass cleaner.
3. Position the wall mount bracket where desired, making sure the top is level.
NOTE: Be sure of your location before removing the remaining protective backing from the adhesive pads,
because they are NOT designed to be removed and repositioned once applied to the refrigerator surface.
4. Remove the protective backing from the two adhesive foam pads, line up the top of the bracket, then firmly press
and hold the bracket in place to ensure that the pads adhere securely.
NOTE: 3M recommends waiting 24 hours for maximum adhesion before mounting the homebase to the wall
mount bracket.
5. Connect the power adapter plug to the DC input connector at the rear of the homebase.
6. Determine how best to route the power adapter wire in reference to the AC wall outlet – to the left or right side of
the homebase – and slip the DC wire into the corresponding wire notch on the back of the unit.
7. Check the amount of wire required to reach the AC outlet; spool any excess wire onto the four posts inside the rear
hollow of the homebase.
8. Attach the homebase to the mount bracket by lining up the homebase bracket mounting holes with the wall brack-
et mounting pads; slide the homebase down until the mounting tabs fully engage the mounting hole slots.
9. Cover the power adapter wire with either the clear, black or white wire cover (to match your refrigerator); seal the
cover using the double-sided tape provided, and then press into place, adhering it onto the refrigerator surface.
DPF711K
Adhesive
Foam Pads
DC Input
Connector
homebase Bracket Mounting Holes
Wall Mount Bracket
Power Adapter
Wire Notches
Wire Post(s)
Power Adapter
Wire Notch
Refrigerator
Door Seal
homebase
Wire Cover
Wire Cover
1inch
DC Power Wire
Refrigerator Door Front Surface
HB-711-OM-128-8270-Eng.qxp 6/5/08 9:37 AM Page 7