Axis Communications 210/211 Security Camera User Manual


 
11
AXIS 210/211 - Accessing the Camera
Focusing
To focus the AXIS 210, simply turn the adjustment ring on the lens until the focus is
satisfactory.
To focus the AXIS 211, follow the instructions below.
1. From the Basic Configuration page in the setup tools, open the Focus adjustment
page.
2. Set the DC-Iris to Disabled
and click Save.
3. Unscrew the zoom puller on
the lens by turning it
anti-clockwise. Adjust the
zoom setting as required.
Re-tighten the zoom puller.
4. Unscrew the focus puller on
the lens. Adjust the focus as
required. Re-tighten the focus
puller.
5. From the Focus adjustment page, set the DC-Iris to Enabled and click Save.
Note:
The DC-Iris should always be disabled while focusing the camera. This opens the iris to its maximum, which
gives the smallest depth of field and thus the best conditions for correct focusing. When the focus is set
with this method it will then be maintained in any light conditions.
AXIS 211
Focus puller
Zoom puller
(Tele/wide)