Filter
Top Products
AXIS Q6044-C PTZ Dome Network Camera
Multi-Connector Cable
Multi-Connector Cable
The supplied multi-connector cable is required in order to maintain the camera’s IP rating.
Connect the multi-connector cable to the camera’s multi-connector and to the connectors in the supplied media converter switch,
see page 6 .
The cable provides the following signals:
• DC power
• Network (Ethernet 10/100Base-T)
• Input/Output (I/O)
1 8
2 7
9
3 6
4 5
Function Pin – wire Notes
Specications
2 – blue
Digital input – Connect to GND to activate, or
leave oating (unconnected) to deactivate.
0 to +30 V DC
Max load =
100 mA
Congurable (Input
or Output)
7 – yellow Digital output – Internal connection to ground
when activated, oating (unconnected) when
deactivated. If used with an external relay, a diode
must be connected in parallel with the load, for
protection against voltage transients.
Max voltage =
+30 V DC
RX+
3 – green/white
Ethernet – receiving
RX-
4 – green
Ethernet – receiving
TX+
5 – orange/white
Ethernet – transmitting
TX-
6 – orange
Ethernet – transmitting
GND
8 – black
Ground
12 V power 1, 9 – red Used to power camera
12–13.2 V DC
Max load = 6 A
57