Filter
Top Products
AXIS Q6044-C PTZ Dome Network Camera
Hardware Overview
Media Converter Switch
1
2
3
4
5
6
7
8
10
9
11
12
13
1
Power connector (DC input)
2
Power connector (DC output)
3
Network connector (internal)
4
Network connector SFP (external) (2x)
5
Network connector RJ45 (external) (2x)
6
Camera LED indicator
7
Network LED indicator (4x)
8
Power LED indicator
9
Ground clip
10
I/O connector (internal)
11
I/O connector (external)
12
Multi-connector cable
13
Ground screw
Media Converter Switch Connectors
For technical specications, see page 62.
NOTICENOTICE
NOTICE
The product shall be connected using a shielded network cable (STP) or an optical ber cable. All cables connecting the
product to the network shall be intended for their specic use. Make sure that the network devices are installed in accordance
with the manufacturer’s instructions. See Electromagnetic Compatibility (EMC), on page 2 for regulatory requirements.
Important
The media converter switch does not support hotswapping. Disconnect power from the switch before swapping cameras. An
attempt to hotswap could cause the switch to freeze, in which case it must be restarted.
Power connector (DC input) - 2-pin terminal block for power input.
Power connector (DC output) - Two 2-pin terminal block for power output (pin 4 is not used).
Network connector RJ45 (external) - Two RJ45 connectors (10/100Base-T) for network connectivity.
8