Filter
Top Products
14 en | Initial Preparations EX14 Marine Camera
F.01U.240.878 | 1.0 | 2011.07 Instruction Manual Bosch Security Systems, Inc.
3 Initial Preparations
1. Determine the operating voltage at the installation site.
The camera’s Voltage Regulator Board accepts 12-24 VDC/
VAC input without change to internal connections
2. Determine the optimum mounting location for the camera.
See Section 4 Camera Mounting, page 15.
3. All cameras have been tested and pre-focused with
telephoto setting as factory default prior to shipment. If
any adjustment needed, it is advisable to check the
camera’s operation before installation.
3.1 Installation Guidelines
– Refer to Section 4 Camera Mounting, page 15, for
installation instructions.
– It is important that these steps are followed in numerical
order.
– This installation must be made by a qualified service
person and must conform to all local codes.