Filter
Top Products
18 en | Camera Connections EX14 Marine Camera
F.01U.240.878 | 1.0 | 2011.07 Instruction Manual Bosch Security Systems, Inc.
4. Remove the desiccant from the plastic bag.
5. Place the desiccant into the enclosure on the side
opposite of the cable connections.
6. Tighten the nut of the gland to 1.3 NM torque setting and
ensure it is sealed well.
7. Perform any required adjustments as detailed in
Section 5.1 Camera Adjustments, page 18 and
Section 5.2 LED Array Adjustments, page 19.
8. Close the enclosure and make sure the sealing gasket is in
place and the round tab at the top of the window locks
into the top inside of the housing.
5.1 Camera Adjustments
This section contains instruction for adjusting the Focus and
Zoom settings.
1. Loosen and tilt back the camera’s top cover to access the
lens for adjustment.
2. Loosen the lens setscrews for focus/zoom adjustments.
See Figure 5.1 on Page 18.
– The setscrew for N --- ∞ is used for image focus
(item 1, below).
– The setscrew for T--- W is used for telephoto or wide-
angle settings. (item 2, below)
3. Re-tighten the setscrews after focus adjustments have
been completed.
TW
N