Filter
Top Products
MegaPixel IP CamerasSoftware | en 19
Bosch Security Systems User Manual F.01U.064.422 | V 1.0 | 2007.03
either automatically (as in Basic mode) or manually, if spe-
cific values of IP addresses are required.
Fig. 4.4 Bosch Camera Installer - Advanced mode
The "Advanced" mode provides the following set-up functions:
Automatic - this function installs the cameras and
verifies their operation. It is similar to the Auto-
matic function in the Basic modes. However, in
the Advanced mode the Automatic installation only acts on
those devices that were highlighted by the user from among the
cameras displayed in the Present Cameras window. Select all
active cameras using the Ctrl or Shift click combination.
Find Cameras - this function will locate all cam-
eras that are present on the local network and
are accessible by the broadcast request. At the
completion of this operation, the installer will show all detected
cameras.
Set IP - this function allows the user to program a
specific IP address in the camera. If the camera
has already been found by the Find Cameras
function, then the user should highlight that camera, type the
desired IP address in the New Camera IP window, and click Set
IP. If the camera cannot be found by the Find Cameras function
due to the fact that the existing firewall settings block broad-
cast requests, the user may still be able to change the camera
IP number. Type both the camera Ethernet (MAC) address and