Filter
Top Products
FlexiDome2X Installation | en 17
Bosch Security Systems Installation Manual AR18-08-B010 | v1.0 | 2009.03
To disassemble the unit proceed as follows:
1. Use the special screwdriver bit to loosen the three tamper-
resistant screws in the trim ring (the screws remain in
place).
2. Remove the trim ring and dome by pulling them from the
base.
3. Remove the inner liner (with sealing ring) by pulling it off
of the base.
4. Remove the pink protective foam.
3.3 Mounting the unit
There are several ways to mount the unit. The method of
mounting depends on the type of surface and whether other
mounting hardware, such as an electrical box, a surface box or
other accessories are used.
Note:
If the unit is to be surface mounted, then use the Surface Mount
Box (SMB). The SMB is sold as a separate item (VDA-455SMB)
or is included with the FlexiDome2X with the surface mount
option. Other mounting accessories are also sold separately.
3.3.1 Mounting tips
– Use the mounting hole template to assist in marking the
correct position for the camera to be mounted.
– Refer to the dimensions on the mounting hole template to
find the exact position of the screw holes and the entry
hole for the cables.
– Partially screw in two screws for the keyholes and use
them to temporarily hang the camera while the
connections are made.