Filter
Top Products
FlexiDome2X Troubleshooting | en 47
Bosch Security Systems Installation Manual AR18-08-B010 | v1.0 | 2009.03
6 Troubleshooting
6.1 Resolving problems
The following table is intended to help you identify the causes
of malfunctions and correct them when possible.
6.2 Customer service
If you cannot resolve a fault, please contact your supplier or
system integrator, or contact Bosch Security Systems
Customer Service directly.
The Installer should write down all information regarding the
unit so that it can be referenced for warranty or repair. The
version numbers of the firmware and other status information
can be seen when the unit starts or by opening the Install
menu. Note down this information and the information found
on the camera label before contacting customer service.
Malfunction Possible causes Solution
No image
transmission to
remote location.
Defective camera. Connect a local monitor
to the camera and check
the camera function.
Faulty cable connections. Check all cables, plugs,
contacts and
connections.
When using DC power
ensure that polarity is
correct.
No connection
established, no
image transmission.
The unit's configuration. Check all configuration
parameters.
Faulty installation. Check all cables, plugs,
contacts and
connections.