Filter
Top Products
FlexiDome2X Connection and set-up | en 27
Bosch Security Systems Installation Manual AR18-08-B010 | v1.0 | 2009.03
4.2.5 Closing the unit
When the camera position is set and all adjustments have been
made, close the unit.
1. Place the inner liner (with attached sealing ring) in
position, aligning its fin with the bracket on the base.
2. Place the dome onto the base and rotate until it clips into
place. (If necessary clean its surface with a soft cloth.)
3. Place the trim ring over the dome.
4. Align the tamper-resistant screws in the trim ring with the
threaded ends in the mounting base.
5. Use the special screwdriver bit supplied to tighten the
three tamper-resistant screws.