Filter
Top Products
89
E
Editing
Do not connect/disconnect any cables to/from the camcorder when dubbing audio
or preparing to dub audio.
1. Locate the point where you want to start audio dubbing, then press
the PAUSE button.
• You can use the playback buttons on the body of the camcorder or the
special playback functions on the wireless controller in the same way as in
playback mode.
• The camcorder becomes set to playback pause mode.
2. Press AUDIO DUB.
• AUDIO DUB. and appear on the display.
3. Press the PAUSE button.
• Audio dubbing starts.
• Direct your voice into the microphone.
• changes to .
4. When you get to the point where you want to stop dubbing, press
the STOP button.
• Audio dubbing stops and AUDIO DUB. disappears from the display.
• The camcorder returns to stop mode.
• You can also set zero set memory ( 75) at the place you want to stop
audio dubbing, then every time you return to that position, audio dubbing
will cancel.
• If instead of pressing STOP you press PAUSE, the camcorder will return to
the playback pause mode.
Notes:
• You can not use the DV terminal while adding sound.
• You might want to adjust the audio mix ( 93) when playing back a tape with
added sound.
• There may be a loss of sound quality if you add sound to a tape recorded on a
camcorder other than the MV500.
• After adding sound 3 or more times to the same place on a tape, there may be
some loss in sound quality.
POWER
CAMERACAMERA
PLAY(VCR)
OFF
REW
PLAY
FF
SEARCH
SELECT
ZERO SET
MEMORY
AUDIO
DUB.
STOP
PAUSE
SLOW
+ /
– /
×2
Dubbing
PLAY
(VCR)
#4_ MV500/MV500i__E(76-95) 2/6/02 14:18 Page 89