Filter
Top Products
97
Playback/Erasing
5
Attaching Sound Memos to Images
In Playback mode (including single image playback, index playback,
magnified playback and the review immediately after shooting in
Shooting mode) you can attach sound memos (up to 60 seconds) to
an image. The sound data is saved in the WAVE format.
1 Press the button while playing back images.
The sound memo control panel will display.
2 Use the or button to select
(Record) and press the FUNC./
SET button.
z You can select it by turning the multi control
dial.
z The recording starts and the elapsed time is
displayed. Speak towards the microphone of
the camera.
z To stop playback, press the FUNC./SET
button. To restart recording, press the FUNC./SET button again.
z You can add as many sound memos as you like until their total time
reaches 60 seconds.
z If the memory card becomes full during recording, the camera emits a
sound to inform you, and recording stops automatically.
z Movies recorded at 640 ¯ 480 or 320 ¯ 240 pixels (30 f/s) and with
the video signal set to the PAL format may play back with a frame rate
lower than the recorded rate when output to a TV or video. You can
play every frame by using the slow motion playback. To check the
images at the original frame rate, you are recommended to play the
movie back on the camera's LCD monitor or on a computer.
z Movies shot with other cameras may not be played back or edited on
this camera. See List of Messages (p. 122).
Sound Memo Panel