Filter
Top Products
Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections 25
Fitting a VTR
1 Set the PRO 76-pin DIGITAL
connector on the DSR-1/1P.
(The camera connector on the
PVV-3/3P is PRO 50-pin.)
For details, see the operating
instructions for the DSR-1/1P.
2 Loosen the two screws and
remove the shoulder pad.
3 Align the projection on the
bottom of the DSR-1/1P with
the slot on the camera head.
This section explains how to attach the DSR-1/1P to
the camera head. The method for attaching a PVV-3/
3P is similar.
When replacing the camera head grip with a camcorder
grip, see “Using the Camcorder Grip” (page 27).
Camera connector
(PRO 76-pin DIGITAL)
DSR-1/1P
Projection
Camera head
Slot
Groove
(continued)
Screws