Filter
Top Products
54 Chapter 4 Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus
Viewfinder Normal Indications
During normal operation, the following items can be
indicated in the viewfinder.
The significance of each of the indications shown in
the figure is as follows.
1 VTR operation status indication
This indicates the VTR’s current operation status
(REC, PLAY, etc.).
2 TAKE/CUE indication
This displays a TAKE or CUE indicator when using
the ClipLink function and recording with the DSR-1/
1P.
TAKE: When recording in Mark mode, this
indication appears when a Mark IN point is set
and disappears when the next Mark OUT point is
set.
CUE: When recording in Cue mode, this indication
appears for about 1 second when a cue point is set.
3 Recording time or time data indication
This shows the following values.
• When the REC TIME switch on the camera is in the
TTL position: The total recording time
• When the REC TIME switch on the camera is in the
DUR position: The duration of the current recording
cut
• With a VTR connected, when the REC TIME switch
on the camera head is in the OFF position and the
item TC IND in advanced menu page 6 is set to
“ON”: A time data value from the VTR depending on
the DISPLAY switch settings on the VTR as shown
in the following table
When using the DSR-1/1P, time data values appear
during playback, fast forward, rewind, or recording
review.
4 NG indication
An “NG” (No Good) indicator appears if you
designate a recorded scene as “NG” when using the
ClipLink function and recording with the DSR-1/1P.
REC TAPE NEAR END
TAKE
TCG 12:34:56:00
W:A
NG AUTO BLACK
SKIN
CLIPM
-OK-
EVS
198
F5.6
DRP 18dB
EZ FOCUS
56ND
:LOW LIGHT 99 04 01
SS :1/100 10:00
AM
30-25 BATT:14.4V
a) Displayed only when a DSR-1/1P is connected.
b) Displayed only when a PVV-3/3P is connected.
c) Whether or not to display can be selected by menu setting.
d) This is recorded over the picture being shot.
qd VTR warning indication
a), b)
qh EVS indication
qj Lens f-stop indication
c)
qk Gain indication
c)
ql Filter setting indication
c)
w; Clock indication
a), b), c), d)
wa Voltage/error indication
ws Shutter setting indication
c)
qf White balance indication
c)
qg SK/N DTL indication
c)
1 VTR operation status indication
a), b)
2 TAKE/CUE indication
a)
3 Recording time or time data
indication
a), b), c)
4 NG indication
a)
5 Clip mode indication
a)
6 Clip remaining
indication
a)
7 Status display area
8 EZ FOCUS indication
9 LOW LIGHT indication
c)
0 Camera microphone output
indication
c)
qa Audio recording level indicators
a), b), c)
qs Tape remaining indication
a), b), c)
DISPLAY switch
setting
Time data displayed
COUNTER CNT: Tape transport time
TC TCG: a time code from the time code
generator
TCR: a time code from the time code
reader
UBG: a user bit value from the user
bit generator
U-BIT