Filter
Top Products
Chapter 4 Viewfinder Screen Indications and Menus 57
Chapter 4 Viewfinder Screen Indications and Menus
wa Voltage/error indication
The current voltage is displayed whenever the camera
head’s power supply voltage dips below 11.0 V DC.
However, you can also display the current voltage at
any time by pressing and holding the MENU/STATUS
switch in the upward position (the display is shown for
as long as you hold the switch upward).
An error message is displayed when an abnormality
has been detected by the auto diagnostic function
(page 62).
If an error message appears, contact your Sony dealer.
If using a VTR and an Anton Bauer Intelligent
Battery System
The remaining battery capacity is shown as a
percentage.
ws Shutter setting indication
When the SHUTTER switch has been set to ON, the
shutter speed, CLS frequency or EVS set in basic
menu page 1 is displayed here.
Status Indications
If you set the MENU/STATUS switch to STATUS
while a menu is being displayed, the camera head’s
current setting status will be shown in this display
area.
a) When both the DCC+ and DynaLatitude
functions are set to OFF
Display
Description
WHITE White balance adjustment method
selection (PRE/A/B) and color
temperature during auto white
balance adjustment
A.IRIS
FILE STD (when not using the setup files),
or a selected file name (when using
the setup files) (see page 71).
Iris adjustment method selection
(STD/SPOT L/BACK L)
For DCC+ indication: ON with the
OUTPUT/DL/DCC+ switch set to
CAM/DCC+ (DCC+ON), and OFF with
the switch set to CAM/DL and DL in
advanced menu page 2 (page 64) set
to OFF (both DCC+ and DynaLatitude
OFF).
For DL indication: When setting the
OUTPUT/DL/DCC+ switch to DL and
DL in advanced menu page 2 to OFF
(DynaLatitude OFF), LOW, STD or
HIGH is displayed according to DL
LEV setting in basic menu page 2
(page 59).
DCC+ or DL