Filter
Top Products
CHAPTER 5 PICK-UP/FEEDING SYSTEM
COPYRIGHT
©
1999 CANON INC. CANON PC800s/900s REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
5-21
Figure 5-205
Figure 5-206
Hex wrench
[10]
Pickup roller shaft
[11]
Pickup gear unit
7) Using a hex wrench or the like, push the
hook [10] of the pickup roller through the
hole to remove the pickup roller [11].
Caution:
When removing the pickup roller, be
sure to push the claw while holding the
shaft in place so as to prevent the pickup
roller shaft from freeing itself.
Caution:
When mounting the multifeeder unit,
perform the next steps first:
1) Turn on the power switch; then, se-
lect the multifeeder, and press the
Copy Start key.
2) When the pickup gear unit has moved
up as far as it can, turn off the power
switch.
3) Mount the multifeeder; then, make a
copy using the multifeeder.