Filter
Top Products
154
If there is a problem, first refer to this Troubleshooting Guide. If this
Troubleshooting Guide does not resolve the problem, contact your
dealer or nearest Canon Service Center.
¡ You are using the wrong battery.
s Use Battery Pack NB-2LH.
¡
The battery pack is not properly attached to the battery charger.
s Attach the battery pack properly to the charger. (p.20)
¡ The battery is exhausted.
s Recharge the battery pack. (p.20)
¡ The battery is not installed properly.
s Install the battery properly. (p.22)
¡ Battery compartment cover is not closed.
s Close the battery compartment cover securely. (p.22)
¡ CF card slot cover is not closed.
s
Close the CF card slot cover securely.
(p.26)
¡ If you set the power switch to <2> right after shooting, the
access lamp will still light/blink for a few seconds until the
camera finishes recording the image onto the CF card.
s When the camera finishes recording the image to the CF card, the
access lamp will stop blinking and the power will turn off
automatically.
¡ The battery is not fully charged.
s Recharge the battery fully. (p.20)
¡ The battery’s service life has expired.
s Replace the battery pack with a new one.
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the power switch is set to <
1
>.
The access lamp still blinks even when the power switch is set to <
2
>.
The battery becomes exhausted quickly.