Filter
Top Products
2-17
Step 4 Install the Camera
Initial Setting and Installation of Camera
2. Remove the dome case and cable cover from the camera.
• To remove the dome case, loosen the two screws on the side face of the camera.
Loosen the screws until they project.
• To connect various interface cables (audio, I/O, power), remove the cable cover lock
screw at the bottom of the camera.
3. Affix the safety wire to the camera and also to the installation location (anchor or structure in
the ceiling, etc.).
Note
When removing the dome case, be careful not to scratch or dirty the dome.
Note
The wire direction is different depending on how the camera is installed.
Dome case lock screw