Filter
Top Products
180
EDITING IMAGES
IMPORTANT!
• Performing Dynamic Range correction on an image causes
the new (corrected) version to be stored as a separate file.
• When you display a corrected image on the camera’s
monitor screen, the date and time indicates when the
image was originally recorded, not when the image was
corrected.
You can perform the following cut operations on the camera to
edit movies you have recorded.
IMPORTANT!
• When you edit a movie, only the result is saved. The
original movie is not retained. Once you perform an editing
operation, you will not be able to undo it.
• A movie that is shorter than five seconds cannot be edited.
• The movie editing operation is supported only for movies
that were recorded with this camera.
• You will not be able to edit a movie if the amount of
remaining memory capacity is less than the size of the
movie file you want to edit. If there is not enough memory
available, delete any files you no longer need to free up
more.
• Cutting a movie into two parts or splicing of two movies in
to a single movie cannot be performed on the camera.
1. Play back the movie you want to edit.
2. Press [SET] to pause
playback.
• Check to make sure that
“” (cut icon) is
displayed on the monitor
screen. If it isn’t, press
[SET] again.
Editing a Movie on the Camera
Operation Description
Cut
(To-Point Cut)
Cuts everything from the current
location to the beginning of the movie.
Cut
(Point-To-Point Cut)
Cuts everything between two points.
Cut
(From-Point Cut)
Cuts everything from the current
location to the end of the movie.
Cut icon
C