Filter
Top Products
ÉPIX™ Drive 640 User Manual
Page 10 of 14
Mounting
Before mounting this product, read the Safety Notes in this User Manual.
Orientation
Always mount this product in a safe position and make sure there is
adequate room for ventilation, configuration, and maintenance.
Rigging
The ÉPIX™ Drive 640 has six (6) mounting points with 10 mm holes.
CHAUVET® recommends using the following general guidelines
when
mounting this product:
•
When selecting an installation location, consider easy access to this
product for operation, programming adjustments, and routine
maintenance.
• Make sure to mount this product away from any flammable material
as indicated in the Safety Notes section.
• Never mount in places where rain, high humidity, extreme
temperature changes, or restricted ventilation may affect the product.
• If hanging this product, make sure that the mounting location can
support the product’s weight. Refer to the Technical Specifications
section for the weight-bearing requirements of this product.
Procedure
The ÉPIX™ Drive 640 has four (4) mounting points (one on each corner)
with 10 mm holes to which you can install screws and mount
this product
directly to almost any flat surface in any orientation.
The ÉPIX™ Drive 640 also has two (2) mounting poi
nts centered on each
end of the product to install clamps for hanging. You must
supply your
own clamps and make sure the clamps
are capable of supporting the
weight of this product.
Product
Mounting
Diagram