Safety Instructions
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance of this
product.
• Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that
the
y also receive this instruction booklet.
• Always make sure that you are connecting to the proper voltage, and that the line voltage you are
connecting to is not higher tha
n that stated on the decal or rear panel of the fixture.
• This product is intended for indoor use only!
• To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no
flammable materials close to the unit w
hile operating.
• The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
• Always disconnect from power source before servicing or replacing lamp or fuse and
be sure to
replace with same lamp source.
• Secure fixture to fastening device using a safety chain. Never carr
y the fixture solely by its head. Use
its carrying handles.
• Maximum ambient temperature (Ta) is 104°F (40°C). Do not operate fixture at temperatures higher
than this.
• In the event of a serious operating problem, stop using the unit immediately
. Never try to repair the
unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always use the same type spare parts.
• Don’t connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact CHAUVET at: 954-929-1115.
Intimidator Spot 2.0 HTI Manual 4 2007-01-24/09:36