Filter
Top Products
Replacing Gobos
1) Remove the four screws indicated in
figure A to remove the back of the
head.
Figure A
Figure B
Figure C
Figure D
2) Remove the four screws indicated in
figure B to remove the front of the
head.
3) Orient the fixture so that it looks like
the fixture
in figure C.
4) Remove the glue from the gobo
(figure D
) using tweezers.
5) Remove the retaining spring from the
gobos.
6) Remove the existing gobo, and
replace
with a new gobo.
7) Replace the retaining spring.
8) If desired, add three small dabs of
high-temperature silicone glue to the
retaining spring.
9) Repeat steps 4-8 as many times as
necessar
y to replace all desired
gobos.
10) Replace the front cover and retighten
the four scre
ws removed in step 2.
11) Replace the back cover and retighten
the four scre
ws removed in step 1.
Intimidator Spot 2.0 HTI Manual 9 2007-01-24/09:36