Filter
Top Products
2-4
Cisco Video Surveillance 2611 IP Dome User Guide
OL-24128-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2611 IP Dome
Recessed Mounting in a Ceiling Tile
You can recess-mount the IP dome in a ceiling tile. With this method, the bottom edge of the IP dome
housing is flush with a ceiling. The ceiling tile must be able to support at least three times the weight of
the IP dome. An optional ceiling tile mount is available to reinforce a ceiling tile so that the tile provides
adequate support. You can purchase the ceiling tile mount from Cisco (Cisco part number
CIVS-IPCA-1008=).
To recess-mount the IP dome, perform the following steps. Make sure that the location in which you
install the IP dome can support at least three times the weight of the IP dome.
Note When you disassemble the IP dome for mounting as described in these steps, make sure to remove any
protective packing material that is installed between components.
Procedure
Step 1 Remove the dome and trim ring assembly from the camera housing by turning the assembly
counter-clockwise (see
Figure 2-2).
Step 2 Remove the Privacy shield by squeezing it inward to release it from the four tabs that hold it into place
(see
Figure 2-2).
Step 3 Remove the camera unit from the camera housing by using a Phillips-head screwdriver to unscrew the
two camera unit screws (see
Figure 2-2).
Figure 2-2 Disassembling the 2611 IP Dome Components
1
2
3
4
5