Filter
Top Products
2-12
Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2621 IP Dome
Step 8 Attach the base plate to the conduit base with the four screws, provided (see Figure 2-8).
Figure 2-8 Attaching the Base Plate to the Conduit Base
Step 9 Put the an category 5 or higher Ethernet cable through the appropriate cable entry hole in the conduit
base and the opening in the base plate and connect the cable to the LAN port on the IP dome (see
Figure 1-1 on page 1-3).
Caution Do not lift the IP dome by the Ethernet cable.
Step 10 If the IP dome will not receive PoE, put the power cable through the appropriate cable entry hole in the
conduit base and the opening in the base plate and connect it to the power input on the IP dome (see
Figure 1-1 on page 1-3).
To connect a power cable, use a flat-head screwdriver to depress the brown tabs on the power input and
connect bare positive, negative, and ground wires as shown on the label that is affixed to the IP dome.
Step 11 (Optional) Connect an external speaker, microphone, or both to the Y cable, then connect the Y cable to
the audio port on the IP dome.(see
Figure 1-1 on page 1-3). The Y cable that is included in the optional
audio/video cables accessory kit can be purchased from Cisco (Cisco part number CIVS-IPCA-1017=).
Each device connects to the audio cable through a standard 3.5 mm mini phone jack. A speaker connects
to the green jack, which is labeled “Audio Out.” A microphone connects to the pink jack, which is labeled
“Audio In.”
1 Conduit base
2 Base plate