Filter
Top Products
2-13
Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2621 IP Dome
Step 12 (Optional) Use the GPIO ports to connect external devices that trigger alarms (connect through alarm
input ports) or respond to alarms (connect through alarm output ports).
See Figure 1-1 on page 1-3.
Step 13 Attach the camera unit to the base plate by aligning the three tabs on the camera unit with the slots on
the base plate, pressing the camera unit into the base plate until the tabs snap into place, and securing
the camera unit with the two camera unit screws (see
Figure 2-9).
Figure 2-9 Attaching the Camera Unit to the Base Plate
Step 14 See Figure 2-16 on page 2-27 and take these actions to adjust the camera lens to obtain the desired
image:
• Temporarily attach an analog monitor to the IP dome so that you can see video while adjusting the
camera. If the cable from the monitor terminates with a 3.5 mm jack, plug it into the analog video
output port on the IP dome. If the cable terminates with a BNC connector, connect it to the mini
cable with BNC adapter, then plug the cable into the analog video output port. The mini cable with
BNC adapter is included in the audio/video cables accessory kit, which you can purchase from Cisco
(Cisco part number CIVS-IPCA-1017=).
1 Base plate
2 Camera unit