Digital Spectrum MF-8000 Digital Photo Frame User Manual


 
Bluetooth
Allows
Bluetooth
connectivity to
either Accept all
pictures
(Default), Reject
all pictures, or
by prompt upon
receipt.
Network Requirement:
If your home network already has a wireless router, you are set. If your home network has a regular
router, you need to purchase a wireless access point. Please refer to the manufacturer of the router and
access point to configure them.
Test your Network/Access Point:
Use your computer to connect to the router/access point, and make sure you can get on the
internet.
In your Digital Picture Frame with slideshow playing:
Press ‘Menu’ on the remote control to go to the main menu
Or at the main menu:
Select ‘Pictures’ and press ‘Enter’
Select ‘Play Slideshow’ and press ‘Enter’
Select ‘Photo Sharing site’ and press ‘Enter’
If ‘Which site would you prefer’ screen is displayed, your network is OK
If not, a list of access points will be displayed
Select your access point.
Important: If your access point is configured with ‘WPA-PSK’ or ‘WPA’. The pass phrase is
case sensitive.
If your access point is secure, a ‘Security key’ screen will display. Use the ‘left’, ‘right’, ‘up’,
‘down’ buttons to navigate the keyboard. Once the key is highlighted, press ‘Enter’ button to
select the character. If you enter the wrong character, select ‘BS’ to clear the character.
Select ‘SHIFT’ key and press ‘Enter’ on the remote control for capital letters or other
characters.
Select ‘SHIFT’ key and press ‘Enter’ on the remote control to return to current keyboard.
Once, you are done entering the security key, select ‘NEXT’ on the keyboard, and press
‘Enter’ button on the remote control.
Digital Picture Frame will attempt to connect to your wireless network. It will take a few
minutes. If the connection is successful, the ‘Which site would you prefer’ screen will display.
If it is not successful, repeat the above procedure. If it fails again, try to place the Digital
Picture Frame closer to your router/access point.
Select ‘From Webshots’ and press ‘Enter’. An album will be displayed.
If no album is displayed, or you encountered an error, please do the following:
The Digital Picture Frame might be too far away from the access point. Move it closer.
Wrong security key might be used. Check your access point security key and repeat the above
procedure.
Auto Configure your Digital Picture Frame:
You will need a computer to auto configure your Digital Picture Frame.
Insert the included CD into a CDRom drive of your computer,