Drive Medical Design 14027 Photo Scanner User Manual


  Open as PDF
of 20
 
11
Always read the operating instructions before use.
Please follow instructions below for detailed operating procedure of each type.
Step 1
Turn on the power. The indicator light on the power switch will come on.
The pump starts to pump air into the mattress.
TheLowPressureindicator(yelloworred)willcomeonasinationundergoes.
Theaudiblealarmisactivated,accompanyingwiththeLowPressureindicator,toalertthatpressureis
low.PresstheAlarmResetbuttontomutetheaudiblealarm,anditsindicatorwillash.
NOTE! For first inflation, we recommend that you press both the Alarm Reset and Static buttons to enter
a quick and silent operation.
Step 2
Whenthepressurereachesthepresetlevelbyfactorydefaultwithinapproximately30~45minutes,the
NormalPressureindicatorwillcomeon,andtheLowPressureindicator(andtheaudible/visiblealarm)
will turn off.
NOTE! If the Low Pressure indicator (and the audible/visible alarm) won’t go off, please refer to page 15
for troubleshooting.
Step 3
Turnthe pressure-adjustknobtosetacomfortablepressurelevelfromsofttorm.(Pressurerange:
30~60mmHgforQ2-02).
NOTE! For suitable pressure, please refer to page 9 for the hand check procedure.
Step 4
The pump is preset in alternating mode and its cycle time is set at 10 min/60Hz or 12 min/50Hz.
Press the Static button to set it in static mode, and the Static indicator will come on. The static mode will
bestartedwithinapproximately6minutes.PresstheStaticbuttonagaintoswitchbacktoalternating
mode.
NOTE! In static mode, the mattress provides a firm surface that makes it easier for the patient to transfer
or reposition. The static mode prevents the patient from bottoming out when in a sitting position.
Step 5
Duringnormal operation,the pump will monitorpressure changes. If the pressure isbelow a user-
denedpressurelevel,thepumpwillautomaticallystarttoinatethemattress.Accompanyingwiththe
Low Pressure indicator, the audible alarm will beep and its indicator will come on to bring attention to a
lowpressurecondition.Thepumpwillstopwhentheuser-denedpressurelevelisreached.
PresstheAlarmResetbuttontomutethealarm;itsindicatorwillash.
PresstheAlarmResetbuttonagaintohavetheaudiblealarmanditsindicatoron.
OPERATION
!
 previous next