Drive Medical Design 14027 Photo Scanner User Manual


  Open as PDF
of 20
 
8
INSTALLATION
Step 1
Placethemattressatlyonthebedframe.
Theinationtubeshouldbetowardsthefootendsothatitcanbeconnectedtotheinationnozzles
on the pump.
Step 2
Youmayplaceathincottonsheetoverthequiltedmattresstopcover.
Step 3
Hangthepumpovertheframeorboardatthefootendofthebedusingthe“hangers”onthebackof
the pump.
Make sure the pump is secured.
Step 4
Connecttheinationtubesfromthemattresstothepump’sinatingnozzles.
Make sure they are properly attached.
NOTE!
Make sure the air hoses are not kinked or tucked under the mattress. Also check to ensure the CPR
valve is properly attached.
Step 5
Plug the power cord into an electrical outlet with grounded AC power.
This product should be grounded!
The power cord has a grounding wire with a grounding pin.
Thisthree-wireplugmustbepluggedproperlyintoanoutletandgroundedasshowninthegurein
the Grounding Instructions section.
NOTE!
Before inserting the plug into the outlet, make sure the voltage is compatible. Also make sure this
product is well grounded.
Step 6
Turn on the power by pressing the power switch at the right side of the pump. Proceed to the Operation
section.
Step 7
Make sure to disconnect the pump by unplugging the power cord when it is not in use.
 previous next