Filter
Top Products
Power Spot 700 II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 47
11. LAMP REPLACEMENT
For a proper and safe lamp change, please read this chapter carefully and follow all
instructions.
Safety Regulations
• Pull out the main plug!
• Wait min. 20 minutes after the last operation to cool down the fixture.
• Don’t touch the bulb of the lamp with bare fingers (this can cause damages.
• Before you put the POWER SPOT 700™ into operation close the casing,
otherwise your retina can be hurt!
• Replace the lamp with an approved replacement type. Be sure to follow all the
lamp handling procedures included with your new lamp. Never handle the new
lamp with your bare hands, the oils from your skin may damage the lamp. Always
replace with the lamp with a lamp that meets the original lamp specification,
failure to do so may damage the unit and will void your manufactures warranty.
Lamp Change
1. Be sure the unit’s main power is disconnect before attempting any service
procedure!
2. Always allow ample time for the unit to properly cool before attempting any type of
service or repair.
3. To allow the best lamp access, use the tilt-lock system to lock the head in 180˚
horizontal position.
4x
4. Using a standard flat head screwdriver release 1/4 turn quick-lock fasteners
(labeled 1, 2, 3, and 4) of the backside lamp sheet and remove it carefully. These