Filter
Top Products
146
ENGLISH
ABOUT RS-232C
ABOUT RS-232C
When the RS-232C terminal is connected to the PC, the Camera can be
controlled from the PC.
To use communication control, be sure to set the Camera and the PC as
follows:
1. Connect the Camera to the PC with an RS-232C cable.
2. Start the PC, and set the communication mode of the RS-232C to the
communication mode of the Camera.
3. Start the program to operate the Camera from the PC.
The RS-232C control starts.
Connecting RS-232C
For Setting up
Note:
• When using a commercial RS-232C cable, make sure that the pins are connected
as shown below.
• To protect the Camera and the PC, be sure to turn OFF the power switch of each
unit before starting the connection work.
Note:
• For the information how to set the communication mode of the RS-232C, refer to
the instruction manual of the PC.
How to connect the cables
54321
9876
1
2
3
4
5
6
7
8
9
CD
RXD
TXD
DTR
SG
DSR
RTS
CTS
RI
CD
RXD
TXD
DTR
SG
DSR
RTS
CTS
RI (CI)
1
2
3
4
5
6
7
8
9
D-SUB 9P (Female)
54321
9876
PC side
D-SUB 9P (Female)
Camera side
(D-SUB 9P)
PC side
(D-SUB 9P)
書画カメラ P30S.book 146 ページ ２００８年１月２４日 木曜日 午後６時３８分