Epson 1640XL Photo Scanner User Manual


 
Using Optional Equipment 43
Loading non-standard sized film
Follow these steps to load non-standard sized film:
1. Place the film directly on the
document table making sure the
glossy (smooth) side of the film
faces down.
If the reflective document mat is
installed in the transparency unit,
remove it.
2. Close the TPU and begin your
scan.
If you’re using EPSON Scan, set the focus position to 0.0.
An area 2±1.5 mm from the horizontal and vertical edges of the
document table glass will not be scanned.
The scanner will generate an error message if the calibration area is
blocked. Also, dirt or dust on the calibration area can result in vertical
lines being added to the image. Keep the calibration area clear and
clean.
Calibration area
1640XL.book Page 43 Wednesday, November 19, 2003 8:46 PM