40 Transparency Unit
Loading 35 mm slides
Follow these steps to load 35 mm slides:
1. Load slides in the 35 mm slide holder as
shown. Make sure the glossy side of each
slide faces down, and the film emulsion
layer faces up.
2. Position the slide holder on
the document table. Align the
slide holder with the notch on
the transparency guide as
shown.
3. Close the TPU and begin your
scan.
If you’re using EPSON Scan to scan, set the following options:
■ If you’re using Home Mode, set Positive Film as the Document Type
option.
■ If you’re using Professional Mode, set the Document Type option to
Transparency, and then set the Film Type option to Positive Film.
1640XL.book Page 40 Wednesday, November 19, 2003 8:46 PM