Filter
Top Products
Using Optional Equipment 37
8. Connect the transparency unit’s
connector to the option
(
ADF/TPU) connector at the
back of the scanner. Tighten the
attached screws to secure
the connector.
If you haven’t connected the scanner to your computer, see the Start Here sheet for
instructions. Then plug the scanner in and turn it on.
See Chapter 2 for scanning instructions.
Using the Film Guides
You can use the four film guides that came with the scanner to scan 35 mm slides,
strips of 35 mm negative or positive film, 120-size or 220-size format film, and
4 × 5-inch film.
When using the film guides, be sure the transparency unit is
completely closed and the calibration area (next to the notch on the
transparency guide) is uncovered or an error will occur and you will be
unable to scan.
Store the reflective document mat in the transparency unit pocket
when not in use.
1640XL.book Page 37 Wednesday, November 19, 2003 8:46 PM