Filter
Top Products
Notices 55
■ Do not let the power cord become damaged or frayed. Place the
document camera in a location where people are unlikely to walk on
the power cord, and the cord is not pinched by items placed upon or
against it.
■ Unplug the document camera and disconnect the cable when not in use,
or when there is a lightning storm. This will prevent damage to the
product due to power surges and lightning.
■ Take care when using a cart to move the document camera that the cart
doesn’t overturn or the document camera fall off.
■ Refer all servicing to qualified service personnel. Do not attempt to take
apart the document camera or open its cabinet, as this may expose you
to high voltage or other dangers.
■ Unplug the document camera and refer servicing to qualified service
personnel under the following conditions: if the power cord or plug is
damaged; if liquid has entered the product; if the product has been
dropped or the case damaged; if the product does not operate normally
or exhibits a distinct change in performance. Adjust only those controls
that are covered by the instructions in this manual.
■ This product includes a lamp component that contains mercury (Hg).
Please consult your state and local regulations regarding disposal or
recycling. Do not put in the trash.
■ To make sure that only Epson replacement parts are used, refer all
servicing to Epson-authorized servicers. Substitution of unauthorized
parts may result in fire, electric shock or other hazards.
■ Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks to determine that the product is in
proper operating condition.
■ Handling the cord on this product or cords associated with accessories
sold with this product will expose you to lead, a chemical known to the
state of California to cause birth defects or other reproductive harm.
Wash hands after handling.
Remote Control Information
You can operate the document camera by remote control via a line-of-sight
infrared (IR) receiver on top of the camera arm. The document camera may
not respond to remote control commands under the following conditions:
■ There is an object between the remote control IR emitter and the IR
receiver on the document camera.
■ Ambient light is too bright.