Filter
Top Products
28 • Installing the Genie Camera Genie Monochrome Series-GigE Vision Camera
• The firmware update is complete when the lower message output area says "Device reset complete". Close the
Device Manager program.
• Genie cameras manufactured in 2007 or later will display the following status LED sequence while initializing
with the new firmware.
• Status LED will flash red then go off.
• Both LAN LEDs will flash repeatedly for a short time.
• Status LED will flash red then go off again.
• Both LAN LEDs will flash repeatedly for a short time again.
• Status LED will turn blue as normally happens during power up.
• Wait for the GigE Server to find the Genie again, then run CamExpert to test the Genie operation (as described
below).
Important: If the Genie power is accidentally cut off during the firmware update (such as a electrical source
power failure or human error), the Genie is easily recovered. See "
Power Failure During a Firmware Update–Now
What?" on page 107.