Filter
Top Products
– 9 –
RM-K1
(1) Operation by Zoom Seesaw Control Lever
a. Set the zoom servo/manual select knob to “SERVO.”
b. Press the zoom seesaw control lever. Press T-side of the lever to zoom to the tele side, and the W-side to zoom to
the wide side. For the speed control, adjust the strength to press the lever. Pressing the lever deeply makes the zoom
speed faster, and shallowly makes slower.
(2) QuickZoom Operation
In quickzoom operation, pressing a switch moves the zoom to the tele end quickly. e operator can use this function
in such occasions listed below.
When rapid zooming to the tele end is required to focus on the object precisely.
To conrm, in a moment, the composition of the image in the extreme closeup shot.
Either the VTR switch or the return switch can be used as a quickzoom switch. Set switch 1 or 2 in the area of
“Function & Mode Select Switches” (see page 13) to ON. When switch 1 is set to ON, the VTR switch acts as a
quickzoom switch, while when switch 2 is set to ON, the return switch acts as that switch. In the following description,
the VTR switch or the return switch is called quickzoom switch.
Operation
a. Set the zoom servo/manual select knob to “SERVO.”
b. Keep pressing the quickzoom switch until the zoom reaches the tele end.
c. While pressing the quickzoom switch, perform precise focusing or conrm the composition of the image in the
extreme closeup shot.
d. Release the quickzoom switch.
– e zoom will move to its former position quickly.
(If you press the quickzoom switch again before the zoom returns to its former position, the quickzoom
movement restarts. Aer this operation, if the switch is released, the zoom will move to its former position
quickly. )
Note 1. In quickzoom operation, the zoom moves at the maximum speed.
Note 2. If you press the quickzoom switch while pressing the zoom seesaw control lever, the zoom moves in auto
cruising zoom operation, not in quickzoom operation.
•
•
RETURN SWITCH
VTR SWITCH