Filter
Top Products
– 4 –RM-K1
ADJUSTMENT
Aer installing the lens to the camera and turning it ON, perform adjustment by watching the monitor of the camera.
For the operation of focusing and zooming, refer to “Focus Operation” and “Zoom Operation” (pages 7 and 8).
a. Loosen the F.f locking knob by rotating it counterclockwise.
b. Operate the zoom to set it to the wide end.
c. Rotate the F.f adjusting ring using the F.f locking knob to focus on the Siemens Star located approximately 3 meters
away. e position where the radial black and white lines become sharpest is the optimum focus position.
d. Operate the zoom to set it to the telephoto end.
e. Operate the focus to bring the object into focus.
f. Operate the zoom to set it to the wide end again, and check that the optimum focus position adjusted in step ‘c’ is
kept.
g. To adjust precisely, repeat the above steps ‘b’ through ‘f’ several times.
(If the most optimum focus position usually holds in all zoom areas, the ange focal length is adjusted precisely. If
it is not focused, the ange focal length is not adjusted suciently. In this case, start adjusting again from step ‘b.’)
h. Finally tighten the F.f locking knob rmly.
F.f ADJUSTING RING
F.f LOCKING KNOB