Filter
Top Products
fi-5530C2 Image Scanner Getting Started 3
Chapter2
INSTALLATION OF THE SCANNER
2.1 Installing the Scanner
1. Place the scanner at its installation site.
For details on the scanner's dimensions and
required installation space, refer to section 7.2
"Installation Specifications" of "fi-5530C2 Oper-
ator’s Guide" on the Setup CD-ROM.
2. Attach the ADF paper chute.
Hold the ADF paper chute and insert its tabs into
the corresponding slots in the scanner as shown in
the figure below.
The Side guides of the ADF paper chute have to
face up.
3. Connect the AC adapter.
1) Connect the AC cable to the AC adapter.
2) Connect the AC adapter connector to the scan-
ner’s DC inlet.
3) Plug the AC cable into the outlet.
2.2 Connecting the Scanner to
Your Personal Computer
Connect either with the USB interface cable or the SCSI
interface cable.
■ Connecting with the USB
Interface Cable
1. Connect the USB interface cable to the USB
interface connector.
ATTENTION
Use only the AC adapter provided by the
manufacturer.
ADF paper chute
Tab
Side guide
HINT
The Function Number Display and the LED
may flash for an instant when plugging the
AC cable into the outlet.
ATTENTION
This scanner is provided with two inter-
faces: Ultra SCSI and USB 2.0 /1.1. Con-
nect only one of the USB or SCSI interface
cable.