Filter
Top Products
Camera body 503CW
Reassembly
May 2000
Revision 1
4:3
Fitting the mechanism plate to the right hand wall
On the mechanism plate fit the upper and lower
connecting rods to the pins on the gear wheels. (13100)
for the upper shutter and (13101) for the lower shutter.
Lubricate with grease. Position the auxiliary shutter stop
(22436) in place.
Place the mechanism plate in position on the right hand
wall. Attach the adjustable pawl assembly (13170) with
two screws (820022). Lubricate the pawl with a drop of
oil and ensure that it is free to operate. Attach the stop
angle (13432) with screw (821017).
Secure the mechanism plate with the remaining three
screws (823015), (820020) and (820015).
Note! The longer connecting rod (13101) which
operates the lower shutter is fitted below the lower-left
mounting post behind the signal arm.
Fig. 17.
Connect the push rod (22369) to the release arm
(13357). Place the arm on the pre-greased pin
(836514).
Fit the S-arm (21167), hub (840701), spring (816914)
and secure into position using screw (821032). Check
for ease of operation.
Connect the spring 816914 to the S-arm and position
the straight end to the pin on the shutter release
connecting rod reverse side. Connect spring (814826)
between the two pins. Check for ease of operation.
Fig. 18.
Fig. 17
Fig. 18
82301513100 820020 820022
13170
13101
820015
13432
13357
21167
816914
814826
22436