Filter
Top Products
Camera body 503CW
October 1996
Revision 0
6:2
The hole for the locating pin (812202) is bored with
1.15 mm drill. Use tool V-2211 for driving in the pin.
Drive the pin in until the face of the tool touches the
front bayonet plate. When a new front plate is installed
the hole must be drilled using tool 902658 (V-2075),
which is equipped with two drill bushes.
Fit the governor (30386) using two screws (820014),
ensure the gears mesh and then secure the screws.
Remove the swarf and lubricate the bevel gears with
grease. Force grease using a syringe into the three small
holes and lubricate the weight of the centrifugal brake.
Note! Do not over lubricate.
Front bayonet plate
Fig. 57
V-2211
1.40 mm