Filter
Top Products
Camera body 503CW
Reassembly
January 2001Revision 1
4:4
Fig. 19
Fig. 20
Fig. 21
Fig. 22
13355
13362
13280
13356-1
816720
30727
Cover 22813
814827
13108
821631
Fit the stop lever (13355) and spring (816752) to the
pre-greased hub. Secure with the clip (817119).
Lubricate the hub (13108) with grease and place a shim
onto it. This shim can be in several thicknesses for
adjustment as follows: 0.10; 0.20; 0.30 mm with
corresponding part numbers 810826, 810827, 810828.
Attach spring (814827) between the auxiliary shutter
stop (22436) and the right hand wall.
Fig. 19.
On the reverse side of the right hand wall fit the mirror
actuating lever (13362) and the lens lock (13280).
Lubricate with grease. The lens lock pin (13280) fits
into a pin on the mirror actuating lever.
Fig. 20.
Secure the mirror actuating lever (13362) temporarily
with screw (821631) from the other side according to
Fig. 19.
Fit the mirror catch 13356-1 onto the pin. Lubricate
with grease. Connect the spring (816720) with its long
shackle in the hole in the right hand wall and the short
one under the mirror catch.
Hold the blocking lever and spring and install the push
fit cover (30727). Check that the mirror catch moves
freely.
Fig. 21.
Connect the right and left hand walls to the bottom
plate (30686), secure with six screws (820014).
Apply safety lacquer to screw-threads.
Put back the foam plastic pad (22582).
Focusing screen frame (22812)
Put the focusing screen frame back and at the same time
secure the upper part of the inner side cover (22813).
Fit the spring (30755) and secure with screws (829425).
Fit four screws (820015), two through the right hand
wall and two (temporarily) through the left hand wall.
Fig. 22.