Filter
Top Products
16
6. Similarly, to copy files from your computer to the internal memory, first locate the files on your computer, select
the files you want to copy, and then drag and drop them into the DPF’s internal memory drive.
TIP: Most cameras and graphic programs store photos in the Windows XP ‘My Pictures’ or Vista ‘Pictures’
folder. If you didn’t save them to any other location, you may find them there.
Disconnect DPF from Windows PC
It is important to always perform a safe PC ‘release’ before disconnecting the DPF USB cable from the PC.
WARNING: Do not unplug or switch off the DPF when files are being transferred, as that can seriously damage the
memory.
Windows Vista
1. On the Windows System Tray, click the hardware removal icon.
2. Click the
Safely remove USB mass Storage device message corresponding with the DPF device drive.
3. When the message “This device can now be safely removed from the computer” appears, you can disconnect the
USB cable from your computer.
Windows XP
1. On the Windows System Tray, click the hardware removal icon.
2. Click
Remove Hardware Safely.
3. Select the storage device corresponding with the DPF, and then click
Stop to disconnect. A final dialog box
opens.
4. Click
Close.
5. When the message “It is now Safe to Disconnect Hardware” appears, you can disconnect the USB cable from
your computer.
Connect DPF to Macintosh Computer
1. Use a USB cable to connect the DPF to your Macintosh computer.
2. Macintosh will recognize the DPF as an external storage device.
3. Drag and drop files between the two devices as you normally move files.
Disconnect DPF from Macintosh Computer
1. To safely disconnect the DPF from your Macintosh, select DPF’s icon on your desktop and press Command-e to
eject the disk.
2. When the icon is no longer on the desktop, it is safe to unplug the USB cable.
Set Sleep Mode
The DPF will stay on until you power it off, however, to save power you can set it to automatically go into a sleep mode
when left idle for a specific amount of time.
1. On the
HOME screen, press
to display the
Setup Menu.
2. Select
Set Sleep Mode, and then select the desired setting.
OFF (default) = Power saver is ‘disabled’; DPF will remain on until you power it off or change the sleep mode setting
2/4/8 Hours = The DPF will automatically go into sleep mode when left idle the specified amount of time
3. Select Done.