Filter
Top Products
Cable type Action
cable to the scanner and then turn on the computer, in
that order.
USB cable The USB cable is connected between the scanner and the
computer.
● Use the cable that was included with the scanner.
Another USB cable might not be compatible with the
scanner.
● Ensure that the USB cable is securely connected
between the scanner and the computer.
For additional USB troubleshooting information, see
www.hp.com/support, select your country/region, and then
use the search tool to find USB troubleshooting topics.
TMA cable The TMA cable is connected between the TMA in the scanner
lid and the scanner base.
● Ensure the cable is securely connected in the back of the
scanner.
● If the connection is good, the blue LED on the top of the
scanner lid will be ON.
Scanner initialization or hardware problems
This section contains solutions for initialization and hardware problems.
Reset the scanner
If you receive an error message similar to “Scanner initialization failed” or “Scanner
not found” when trying to use the scanner, use the following procedure:
1. Close the HP Image Zone software, if it is open.
2. Disconnect the cable that connects the scanner to the computer.
3. Turn the power switch on the back of the scanner to OFF.
4. Turn the computer off, wait 60 seconds, and then turn the computer on again.
5. Turn the power switch on the back of the scanner to ON.
6. Reconnect the cable that connects the computer and the scanner (use a different
USB port on the computer if possible).
● Make sure that the USB cable is connected to the back of the scanner correctly.
The USB symbol on the end of the cable (the connector) should be facing up.
When connected correctly, the USB connector will feel slightly loose. When
connected incorrectly, the USB plug will feel overly tight.
● Try connecting the USB cable to a different USB port on your computer.
Test the scanner hardware
If you think that the scanner has a hardware problem, verify that the cables are firmly
connected to the scanner, the computer, and the power source. If the cables are
Chapter 3
(continued)
18 HP Scanjet 4800 series